Yeah, mostly because of the entire tech industry for the last decade. I’ve gad every ounce of trust incinerated.

Oh, I think they’re communicating just fine. They’re signalling the direction they plan to take and it’s not a good one.

It could, but I don’t think there would be any benefit. The key thing this does is make walls a bit closer to the theoretical perfect solid structure.

Not as drastic as I had hoped, but it looks like around 5% better layer adhesion provided you increase the flow rate slightly to fit in the gaps. It essentially makes a print that’s more solid in the walls.

I saw elsewhere someone doing prints with transparent filament and they were also getting optically better prints with this.

Also, there’s a pull request on Orca… Not sure when it’ll come out, but they’re working on building it into the slicer.