I’m pretty sure I was successful with putting both my Bambu printers on LAN mode and setting up my router to block their connection to the internet before potentially unknowingly updating to this garbage firmware version. We’ll see, definitely not buying another Bambu for the foreseeable future. I bet Prusa is pretty happy about this decision from Bambu.
I’m pretty sure I was successful with putting both my Bambu printers on LAN mode and setting up my router to block their connection to the internet before potentially unknowingly updating to this garbage firmware version. We’ll see, definitely not buying another Bambu for the foreseeable future. I bet Prusa is pretty happy about this decision from Bambu.
Did you just block the device by mac? Or only specific endpoints?
I blocked it using my router’s GUI, I imagine it goes by the MAC address but I’m not sure.
If you looked at the list of LAN clients then blocked one (the printer), then, yes, you blocked the MAC of that client.