Maybe I’m out of the loop, but I was under the impression people paying for the enterprise tier were largely using the model on their own hardware, and that the removal of this tier was largely just rent seeking by SD against people improving on their model and selling access to a better version.

Did SD really sell unlimited access to their compute/ image generator for a fixed price? If so that’s just so dumb it’s hard to believe. I only started paying attention to the company recently though, so maybe I’m missing something.

For me, it didn’t prompt the upgrade when I went to the firmware page, but it did prompt for it when I went into the matter settings page.

I think Switchbot does slow rollouts, but if it’s not available for you yet you can just send them a message in the feedback page of the app and they’ll probably be able push the upgrade to you (I’ve done this a couple of times for previous matter releases).

It’s not thread-based matter to the vacuum directly, but matter over wifi using their Hub 2 as a bridge, but I just tested and it works! The vacuum shows up as a binary OnOff plug, toggling it on starts a cleaning session, and off cancels the session and returns the unit to base.

I should note, I had to update my Hub 2 firmware to V2.0-1.2, which also adds the ability to swap out the temperature and humidity sensors to other devices for being a matter bridge, which is nice.

From UCTronics. Take a look at their selection they’ve got a big range from basic ones like this, some with little displays included, and some that stack vertically to really maximize efficiency, etc.

deleted by creator

I don’t have raw numbers, since it’s running Home Assistant that doesn’t give you a nice way to test disk speed, but the startup is significantly faster. I found it could take a minute or two with the microSD card, but on NVME it seems to be only around 30 seconds until I can access the web UI or SSH in.